Вибери країну доставки

RockBoard RBO POW ISO 12 IEC Блок живлення

Код товару: 1338175

RockBoard RBO POW ISO 12 IEC Блок живлення

Код товару: 1338175

The RockBoard ISO Power Block V12 IEC is an isolated multi power supply built to feed up to 12 effects pedals from a single mains outlet, eliminating the tangle of wall warts behind any pedalboard. Twelve galvanically isolated, highly filtered outputs plus a dedicated 5V USB-A port keep analog and digital pedals free from ground loops and…

RockBoard RBO POW ISO 12 IEC Блок живлення

The RockBoard ISO Power Block V12 IEC is an isolated multi power supply built to feed up to 12 effects pedals from a single mains outlet, eliminating the tangle of wall warts behind any pedalboard. Twelve galvanically isolated, highly filtered outputs plus a dedicated 5V USB-A port keep analog and digital pedals free from ground loops and high-frequency noise. The unit ships with twelve 60 cm flat power cables and an IEC mains lead, ready to mount under a RockBoard or any standard board.

  • 12 transformer-isolated DC outputs (2.1 x 5.5 mm barrel, centre negative) plus 1 USB-A 5V / 2,000 mA port
  • 4 switchable slots deliver 9V/500 mA, 12V/375 mA, 15V/300 mA or 18V/250 mA for high-current DSP pedals
  • 4 fixed 9V/500 mA slots and 4 fixed 9V/250 mA slots cover standard analog stompboxes
  • Compact aluminium housing measuring 195 x 88 x 35 mm and weighing 608 g, with individual short-circuit LEDs per slot
Ще не створено іншого опису твоєю мовою. Можливо, тобі зараз допоможе опис англійською мовою.

Isolated Multi Power Supply for Demanding Pedalboards

The RockBoard ISO Power Block V12 IEC is a multi-power supply designed for guitarists and bassists running larger pedalboards with a mix of analog and digital effects. Twelve transformer-isolated, highly filtered power slots and one 5V USB-A output replace the usual cluster of individual wall adapters, drawing power from a single IEC mains inlet that accepts 100–230V AC at 47–63 Hz for worldwide touring. Advanced filtering technology suppresses the high-frequency noise that digital pedals typically inject into the signal chain, so the rig stays quiet in the studio, in the rehearsal room and on stage.

Standout Engineering for Noise-Free Performance

What separates this unit from a basic daisy-chain setup is true galvanic isolation between every output, which eliminates ground loops between pedals that share the same physical chassis. Each slot also carries its own short-circuit protection and a dedicated status LED, so a fault on one pedal shuts down only that output while the rest of the board keeps running. The compact aluminium housing measures just 195 x 88 x 35 mm and weighs 608 g, fitting comfortably under most RockBoard pedalboards or any standard board with a mounting tray.

Output Configuration and Voltage Flexibility

The 12 DC outputs are split into three banks so players can match voltage and current to each pedal without external adapters or step-up boxes. Four switchable slots cover the full range from 9V up to 18V, while two further banks of four outputs each handle standard 9V analog stompboxes at different current ratings.

  • Switchable Outputs: 4 x 9V DC 500 mA / 12V DC 375 mA / 15V DC 300 mA / 18V DC 250 mA — covers everything from vintage 9V drives to modern 18V DSP units
  • Fixed 9V Outputs (high current): 4 x 9V DC 500 mA — drives current-hungry analog and digital pedals
  • Fixed 9V Outputs (standard): 4 x 9V DC 250 mA — ideal for classic overdrives, delays and modulation pedals

USB Power and Connector Standard

A USB-A port adds 5V at 2,000 mA for charging a phone, powering a small MIDI controller or running a USB-driven accessory without occupying a DC slot. Every DC output uses the industry-standard 2.1 x 5.5 mm barrel plug with centre-negative polarity, matching the cable supplied with the vast majority of stompboxes.

  • USB-A Output: 5V DC, 2,000 mA — powers phones, MIDI controllers or USB accessories
  • DC Connector: 2.1 x 5.5 mm barrel, centre negative — universal fit for standard effects pedals

Build, Dimensions and International Compatibility

The sturdy aluminium enclosure is sized to slide under a RockBoard or sit on top of a pedalboard, and the wide-range IEC input means the same unit works in Europe, North America and most touring destinations without a step-down transformer. The package includes twelve RockBoard Flat Power cables at 60 cm each plus the IEC mains lead, so the board is ready to wire up straight out of the box.

  • Housing: Aluminium, 195 x 88 x 35 mm — compact footprint for under-board mounting
  • Weight: 608 g — light enough not to weigh down a flight case
  • Input Voltage: 100–230V AC, 47–63 Hz — international mains compatibility
  • Package Contents: 12 x 60 cm flat power cables, 1 x IEC power cable — everything needed to connect the board

Мета використання
Функції

Кількість виходів

more than 8

Входи та виходи

Полярність

Center Minus

USB

Так

Упаковка

Вміст пакета

Кабель живлення

Блок живлення

Напруга

9V, 12V, 15В, 18В

Роз'єм

Бочка

Блок живлення

Кабель живлення

Аксесуари

Адаптер в комплекті

Ні

Розміри та вага

Ширина (мм)

88

Глибина (мм)

195

Висота (мм)

35

Вага нетто (кг)

0,608

Країна

Країна походження

Китай

Документи

Інструкції з використання
Інформація про виробника
Виробник:
Warwick GmbH & Co Music Equipment KG
Gewerbepark 46, 08258, Markneukirchen, Німеччина
Відповідальна особа:
Warwick GmbH & Co Music Equipment KG
Інструкції з техніки безпеки

Будь ласка, звернися до посібника користувача, щоб отримати конкретні інструкції з техніки безпеки для цього виробу