Line6 HX Stomp Гітарний мультиефект

Line 6 HX Stomp — Helix Power in a Stompbox

Line 6 HX Stomp delivers the full Helix modeling engine in a chassis barely larger than a standard guitar pedal. It packs over 300 amps, cabs, and effects from the Helix, M-Series, and legacy Line 6 catalogs, running up to six processing blocks at once. The unit works as a super stompbox, backup rig, tone expander, USB audio interface, or full guitar or bass rig.

What Sets the HX Stomp Apart

Built around a SHARC audio engine, the processor combines component modeling — measuring each amp stage — with behavioral modeling that captures analog behavior like germanium fuzz and bucket-brigade delay. Three capacitive-touch footswitches with color-coded LED rings and Snapshots give players instant, dropout-free access to multiple preset variations.

Connections and Signal Routing

MIDI In and MIDI Out/Thru jacks turn the unit into a rig command center, sending Program Change and Continuous Controller messages. Standard 6.3 mm TS jack inputs and outputs handle instrument-level connections.

• Inputs: MIDI IN, 6.3 mm TS jack — mono or stereo
• Outputs: MIDI OUT, 6.3 mm TS jack — unbalanced TS or balanced TRS
• MIDI Interface: Yes — full In/Out/Thru plus USB MIDI
• Two effects loops with 1/4" TRS provide flexible ways to patch external pedals into any preset.

Processing Power and Recording

The SHARC-powered DSP delivers 123 dB of dynamic range and doubles as a multi-channel USB audio interface for direct recording.

• Audio Interface: 24-bit/96 kHz USB — record into a DAW
• Dynamic Range: 123 dB — ultra-low noise
• Cabinet Models: 2048-point IR equivalent — third-party IR support
• Power is supplied by the included DC-3 adapter, as this unit does not support batteries.

Onboard Controls and Layout

Three capacitive-touch footswitches, parameter knobs, and a master volume knob give hands-on access to every parameter without menu diving.

• Controls: Master Volume, Footswitch, Parameter Knob, Control
• Display: 2.4-inch (6 cm) color LCD
• Footswitches: 3 capacitive-touch with LED rings
• Included in the box is a DC-3 adapter, manual, and cable.